BMW 2006 M5, Owner'S Manual

Page: 195 / 231

M
o
bi
lity
193
Re
fe
re
n
c
e
At
a
g
la
n
c
e
Co
n
tr
o
ls
D
riv
in
g ti
ps
C
o
m
m
uni
ca
ti
o
n
s
Na
v
iga
ti
on
En
te
rt
a
in
m
e
n
t
engage a driving position with the selector
lever.
Have all vehicle occupants get out of the vehicle
and ensure that they remain outside the imme-
diate area in a safe place, such as behind a
guardrail.
If a warning triangle
*
or portable hazard warning
lamp is required, set it up on the roadside at an
appropriate distance from the rear of the vehi-
cle. Comply with all safety guidelines and regu-
lations.
Change the wheel only on a level, firm surface
which is not slippery. The vehicle or the jack
could slip to the side if you attempt to raise the
vehicle on a soft or slippery surface such as
snow, ice, tiles, etc.
Position the jack on a firm support surface.
Do not use a wooden block or similar object as a
support base for the jack, as this would prevent
it from extending to its full support height and
reduce its load-carrying capacity.
To avoid serious or fatal injury: never lie under
the vehicle, and never start the engine while it is
supported by the jack.
<
What you will need
To avoid rattling noises later on, note the posi-
tions of the tools before removing them, then
return them to their initial positions after com-
pleting work.
1 Chock
*
2 Vehicle jack
*
3 Lug wrench
*
The tools are located in the hollow of the spare
wheel
*
.
Spare wheel*
1. Pull back lock 1 , fold open clamp lock 2
completely and loosen the belt 3 .
2. Remove the cover 4 .
3. Take the tool mount out of the spare wheel.
4. Remove the spare wheel.
Preparing wheel change
1. Observe the safety precautions above.
2. Prevent the vehicle from rolling:
Place the chock behind the front wheel on
the other side of the vehicle, or on inclines,
in front of this wheel. On a steep grade, take
other steps to prevent the vehicle from roll-
ing.
3. Loosen the lug bolts a half turn.
Jacking up vehicle
1. Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal injury.
<
Online Edition for Part No. 01 41 0 012 213 - © 02/06 BMW AG