16
INSTALLATION CHECKLIST:
□
Cell Unions installed and glued into pipe work.
□
Threaded Collars on either side of the Cell are hand tight.
□
Flow Switch is installed and oriented properly.
□
Control Unit is affixed to wall and wired correctly.
□
Cell Cable and Flow Switch are connected to Control Unit.
□
You have checked and confirmed that Control Unit switches ON and OFF concurrently
with filter pump, or is energized continuously for use with variable speed pump.
□
You have checked all connections and joints for leaks.
□
Sufficient salt has been added and fully dissolved and circulated throughout pool water.
□
Pool has properly balanced water chemistry.
Initial Start Up:
Once installation is complete, ensure that the added salt has been fully dissolved in the
pool, and that the pool is clean and chemically balanced.
Apply power to the pool pump switch (or timer controls). This should activate the system,
and within moments the green LED lights for "Power" and "Generating" should be
illuminated. During this time, you may also see the "No-Flow" light flash for up to 60
seconds as your pump begins its operation.
To find the optimum Chlorine Output setting, start at a setting of 70% and adjust as
needed over the initial start up period. Measure your available chlorine in the pool after
two to three days, and adjust the Chlorine Output level accordingly. If the available
chlorine is too high, lower the Output level; if the available chlorine is too low, raise the
Output level. It will take a few adjustments to find the ideal setting for your pool. Once
determined, it should only take minor adjustments throughout the season.
Summary of Contents for BLSC
Page 1: ...BLSC ...
