13
Wiring to Power Source:
The Control Unit comes with an un-terminated Power Cord (AC Input) which is typically
connected to an external timer, which will turn the pump and Control Unit on and off
together. Have the Control Unit wired to the load side of the timer by a qualified person.
See the following diagram for typical wiring. See voltage warning on page 15.
The is shipped from the factory with a 240 VAC configuration. If 120 VAC is needed, move
the internal jumpers as shown on page 15. If unsure, seek professional advice.
When used with variable-speed or other electronically controlled pumps, you may wish to
wire the Control Unit directly to your power source. This will allow the pump to determine
when the Cell is energized or dormant by activation of the Flow Switch.
Always double-check the voltage of your power source.
Connection to improper voltage
can: a) cause severe damage/harm, or b) cause lights and screen to power on without
system function.
Summary of Contents for BLSC
Page 1: ...BLSC ...
