12
7
4
4
POOL ASSEMBLY INSTRUCTIONS (CONTINUED)
2
2
2
2
8.
Carefully slide the Horizontal Beams (2) into the sleeves of the pool.
9.
Connect the T-Fitting (4) to the Horizontal Beam (2).
IMPORTANT:
The last T-Fitting
(4)
can be difficult to connect. Connect the first side of the Horizontal Beam to
the T-Fitting. Then, angle the second side of the T-Fitting up slightly and begin to push the Horizontal Beam
into the T-Fitting. Finish sliding the Horizontal Beam into the T-Fitting and ensure it is secure.
4
10.1
FOR 18’ POOLS ONLY!
Insert the Pins (6) down through the top of the T-Fittings until the Pins snap into
place on the lower side of the T-fitting.
10.2
FOR 24’ POOLS ONLY!
The Horizontal Beams have factory installed spring clips (18). Carefully rotate the
Horizontal Beam and move in or out until the spring pin aligns and pops into the hole in the top of the T.
WARNING:
The spring pin must be completely seated in the hole of the T-Fitting or your pool will collapse
when you fill with water. This would be an incorrect assembly and would void your warranty.
11.
Carefully slide the Vertical Legs (3) up through the belt that runs around the pool.
TIP:
For smaller pools
without a belt, slide the vertical legs up through the sleeves on the pool wall.
6
3
3
3
3
TIP:
A Philips screwdriver can be
helpful in aligning the holes.
Insert the pins through the
holes until they snap into place.
Continue until all Vertical Legs
are connected and pinned to
the T-Fittings.
