9
POOL SETUP
POOL SITE PREPARATION
Remember ground preparation is the most important step in the installation of the pool. Do
not install the pool over underground power lines, sewer lines, or other structures. Do not
install on cement, asphalt, or other hard surfaces.
1.
Mark off the pool area by driving a stake in the center of the area where the pool will be installed.
Have a helper hold a tape measure or a string and mark off the pool perimeter using flour, chalk, or
spray paint. Remove all sod inside the pool area to 1-ft (30-cm) beyond the dimensions of
the pool.
2.
If the area selected for pool installation has Nut Grass, Bermuda Grass, or any other type of
persistent grass, it is recommended that a topical grass herbicide is applied. Wait at least 48 hours
before continuing with the installation.
3.
After removing the sod, rake the dirt to remove any small rocks, stones, roots, sticks, or other debris
that could cause damage or tear the pool liner.
4.
The use of a tarp or Gorilla Pad
TM
(sold separately) under the pool is recommended. This will help
prevent punctures and damage to the pool liner. Refer to the diagrams below when ordering or
placing the Gorilla Pad
TM
under your pool.
The below diagrams show image references to marking off your pool area. If you bought a 15-ft pool,
reference Diagrams 1 and 2. If you bought an 18-ft pool reference Diagrams 1 and 3.
18’
19’
24’
25’
(Diagram 3)
(Diagram 2)
(Diagram 1)
