UNPACKING
Inspect this device before it is used.
Occasionally, products are damaged
during shipment. If the device or
components are damaged, contact
customer service at 888-636-6628.
Operating Instructions and Parts Manual
BCPA1
3
1.
Status Light - See page 7 for
Light Blinking Pattern Definitions
2.
Low Battery Light - See page 7 for
Light Blinking Pattern Definitions
GETTING TO KNOW YOUR
ADVANCED TEXT NOTIFICATION
DEVICE (FIGURE B)
Do NOT mix old and new
batteries. Doing so will
reduce overall performance and may cause
battery leakage or rupture. When replacing
batteries, always replace all 4 at the same
time.
Using 3 or more batteries
may appear to work
properly even if one is inserted incorrectly.
Such usage may lead to battery leakage
or rupture that could result in equipment
damage.
www.blueangelpumps.com/AdvancedText
Do NOT mix different
battery brands or types.
Doing so will reduce overall performance and
may also cause battery leakage or rupture.
We recommend using the same type of
batteries within a device.
3.
PUSH TO TEST - Sends a text
notification (up to 3) to all
emergency contact phone numbers
the home owner has programmed.
4.
Lower Float Water Sensor Light
-
This light blinks when the bottom
float is activated.
5.
Upper Float Water Sensor Light -
This light blinks when the top float
is activated.
6.
Power Jack - A/C power adapter
plugs in here.
7.
On/Off Switch - Turns the
Advanced Text Notification device
on or off.
8.
Sensor Ports - The 2 dual
float sensors plug in here. See
(Figure B)
1
2
3
4
5
6
7
8
Figure B
Figure 1
Do NOT overtighten screws.
Use of this device and the
ability to send and receive
texting alerts in the event of an emergency, are
contingent upon an active cellular service.
STEP 1 - VERIFY PACKAGE
CONTENTS
a. Before installing your Advanced
Text Notification device, you will
need to check the signal strength/
reception in your basement. To do
this, plug in the A/C power adaptor,
flip the “On/Off” switch to the “On”
position and wait for the status light
to change from a red light to a
blinking green light. Blinking green
indicates you have cellular
reception, (this can take up to 1
minute).
b. Next, flip the “On/Off” switch to
the “Off” position and unplug A/C
power. Remove (4) screws, lift lid
and install (4) AAA batteries.
(Figure 1) The negative (-) end of
the battery must touch the spring.
Replace the lid and (4) screws.
c. Plug in A/C power adapter and flip
the “On/Off” switch to the “On”
position. Wait for the status light to
turn solid green indicating network
connection.
NOTE: If the status light remains
red, go online and check the Verizon
wireless 3G coverage map:
http://www.verizonwireless.com
OPERATING INSTRUCTIONS
STEP 2
a. SIGNAL STRENGTH
b. INSTALL BATTERIES
c. NETWORK CONNECTION
