CLEANING INSTRUCTIONS (continued)
9
PROCEDURE: Clean Coffee Dispenser
PRECAUTIONS: Disconnect dispenser from electric power.
Allow dispenser to cool.
FREQUENCY: Weekly
TOOLS: Mild Detergent, Clean Soft Cloth or Sponge
Soft Bristle Brush, Bottle Brush
1. Disconnect dispenser from electric power.
Allow dispenser to cool.
2.
Remove PRODUCT CANISTERS and DRIP TRAY.
3.
Remove DISPENSING NOZZLES by turning 1/4 turn and
pulling straight down.
4. Remove UPPER and LOWER MIXING CHAMBERS.
Disassemble into separate components.
5. Wash nozzles and mixing chamber components in warm
water with mild detergent. Use appropriate soft brushes to
clean caked-on product.
6. Rinse mixing components with clear water. Drain thoroughly
and allow to air dry.
7. Empty and clean product canisters (See page 10).
8. Empty and clean DRIP TRAY.
9.
Clean DRAIN PAN:
a. If not plumbed to drain, remove, empty and rinse with
clear water. Allow to dry, then reinstall.
b. If plumbed to drain, scrub with a mild detergent solution
and a soft bristle brush. Rinse with clear water.
10. Remove CANISTER SHELF. Wipe VACUUM CHAMBER
and underside of shelf. Reinstall shelf.
11. Wipe interior and exterior of dispenser with a clean cloth
dampened with warm water and mild detergent. Rinse with a
clean cloth dampened with warm water. Be sure to clean
mixing chamber area behind dispense switches thoroughly.
IMPORTANT: DO NOT allow water to drip or spill into any
controls or wiring.
12. Reassemble:
Verify that TANK HEAT SWITCH is
ON
, SOLENOID OFF
ON SWITCH is
ON
, and that SERVE/SANITIZE SWITCH is
in the
SERVE
position.
Reinstall DISPENSE NOZZLES.
Reinstall UPPER and LOWER MIXING CHAMBERS.
Reinstall PRODUCT CANISTERS and DRIP TRAY.
Close all panels and reconnect dispenser to electric power.
Procedure is complete
CAUTION
BURN HAZARD
Dispensing and serving
temperatures of coffee are
extremely hot.
Hot coffee will cause
serious skin burns.
CAUTION
ELECTRIC SHOCK
HAZARD
Do not submerge or immerse
dispenser in water.
DO NOT pour or splash water
into any controls or wiring.
IMPORTANT:
DO NOT use steel wool, sharp
objects, or caustic, abrasive or
chlorinated cleansers to clean
the dispenser or components.
Mixing Components
Assembly Diagram
