TROUBLESHOOTING SUGGESTIONS
12
SYMPTOM
POSSIBLE CAUSE
SUGGESTED REMEDY
Water won’t heat
Brewer unplugged or circuit
breaker tripped
Check power supply cord
Check / reset circuit breaker
Temperature adjusted too low or
set to
OFF.
Set to on and set for desired
temperature. See page 15
Hi-Limit safety switch tripped
Access hi-limit by removing front
panel. Hi-limit is on the left side
of the tank. Use an insulated
tool to push the red button in until
it “clicks” and stays.
Damaged internal component or
wiring
Allow to cool
Examine wiring & connectors,
controller, power board and heat-
ing element
Repair/replace as needed
Coffee level too high or low
Timer out of adjustment
Adjust controller. See page 16
Too many filter papers or wrong
filter paper
Use one (1) genuine Bloomfield
filter per brew
Brew chamber overflows
Brew chamber dispense hole
plugged
Thoroughly clean brew
chamber
Too much coffee or too fine a
grind
Use correct grind and amount of
coffee
Sprays water from brew head
Spray gasket improperly installed Check/reinstall gasket on INSIDE
of brew head
Spray disk plugged or installed
upside down
Clean spray disk and install with
ears “up”
No brew (faucet flows OK)
Damaged internal component or
wiring
Check keypad, controller, power
board & solenoid
Repair, replace as needed
No brew plus no flow from hot
water faucet
Water supply OFF
Turn water supply ON
Solenoid inlet strainer plugged
Clean strainer
Water filter (if used) plugged
Replace filter element
Faucet valve turned OFF
Turn faucet valve ON
Faucet plugged
Disassemble faucet, clean
Poor coffee quality
Keep brewer and decanters clean.
Install a taste and odor filter in water supply, and replace cartridges
regularly.
Use a quality coffee with a consistent roast. Use proper grind and
amount of coffee per brew.
No flow from hot water faucet
Main warmer inoperative
Warmer Fuse blown
Check wiring for moisture
Replace 10 amp fuse
