24
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault
that you can rectify yourself using the following
instructions. Do not perform any other work on the
appliance if the following information does not provi-
de assistance in your specific case.
• Only leave door open as long as necessary.
• Do not set temperature any colder than neces-
sary.
• Put frozen food in the fridge to defrost. The
cold in the frozen food will then be used to cool
the fridge.
• Keep the heat emitting condenser, the metall
grille on the rear wall of your appliance, always
clean.
Malfunction
Possible Cause
Remedy
Appliance does not work, no pilot light is illu-
minated.
Appliance is not switched on
Switch on the appliance.
Mains plug is not plugged in or is loose.
Insert mains plug.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Socket is defective.
Mains malfunctions are to be corrected by
an electrician.
Green light does not light up, yellow light
lights up when fast freeze fuction is activa-
ted, appliance is on.
Green light faulty.
Please inform your customer service
Yellow light does not light up, when fast
freeze fuction is activated, appliance is on.
Yellow light faulty.
Please inform your customer service
• Do not install the appliance near cookers, radia-
tors or other sources of warmth. High ambient
temperatures cause longer, more frequent opera-
tion of the compressor.
• Ensure sufficient air circulation and exhaust at
the appliance base and at the back wall of the
appliance. Never cover air vent openings.
• Do not place warm foods into the appliance.
Allow warm foods to cool first.
2. Defrost the freezer compartment prior to cleaning
(see "Defrosting" section).
3. Switch the appliance off and remove the plug
from the mains, or switch off or turn out the cir-
cuit breaker or fuse.
4. Clean the appliance and the interior accessories
with a cloth and lukewarm water. Commercially
available dish washing detergents may also be
used.
5. After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser
increases energy consumption. For this reason
carefully clean the condenser at the back of
the appliance once a year with a soft brush or a
vacuum cleaner.
Energy Saving Tips
Warning! Repairs to refrigerators/freezers may only
be performed by qualified service engineers. Impro-
per repairs can give rise to significant hazards for the
user. If your appliance needs repairing, please con-
tact your specialist dealer or our Customer Service.
Appliance cools too much.
Temperature is set too cold.
Turn the temperature regulator to a warmer
setting temporarily..
29
Dimensions de la niche
Hauteur
880 mm
Profondeur
550 mm
Largeur
560 mm
Changement du côté d’ouverture
de la porte
La butée de porte peut être déplacée de la droite
(position d’origine) à la gauche si le lieu d’installation
le nécessite.
Attention ! Pendant le déplacement de la
butée de porte, l’appareil ne doit pas être branché sur
le secteur. Débrancher préalablement la fiche secteur.
Votre réfrigérateur a besoin d’air
Pour des raisons de sécurité, la ventilation doit être
prévue comme indiqué dans la Fig.
Attention: veillez à ne pas obstruer les overtures
de ventilation.
50 mm
min.
cm
2
200
200 cm
2
min.
D567
D765
Coller le cache-jointure sur l’appareil comme l’indi-
que le dessin.
Instructions pour l’encastrement
