Installation
14
Adjustments
Before applying power to the appliance for the first
time, check for the following conditions:
j
All āelectricalā safety provisions have been adĆ
hered to and the electrical connections are
correct.
j
The āābake enhancer āand āholder āare āin ātheir
proper positions.
j
The āpanā holders are āinserted āinto the oven
cavity.
DOOR ADJUSTMENT
The door catch may be adjusted in two directions,
in and out, and up and down, using the following
procedure:
1. Adjust up and down by loosening the two
boltsā holdingā theā catch to the face of the apĆ
pliance. See Figure 8 (A).
2. Make āadjustmentsā soā thatā theā leadingā face of
the latch is centered in the opening of the hanĆ
dle assembly.
3. Tighten the bolts so that there is no further
movement.
4. Adjust in and out by loosening the bolt on top
of the catch. See Figure 8 (B).
5. The āāadjustment āāface āāis āstepped āso āthat moveĆ
ment is limited with the bolt tightened properly.
6. The āadjustment āis ācorrect āwhen āthe ādoor
closes firmly and no steam leaks from the gasĆ
ket.
The hinges can also be adjusted as follows:
1. Be certain the latch is adjusted properly.
2. Adjustā hinges āso āthatā the door back and the
appliance face are parallel. See Figure 8 (C).
3. The adjustment is correct when no steam
leaks through the gasket.
A
B
C
Oven
Door
Figure 8
