BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
17
Issue 01 D1
Figure 6 Attaching Assembled Pole/Wall Mount Bracket to Pole with U-Clamp or V-Clamp
6.3.3
Mounting with Steel Straps
Use steel straps to mount the modules onto poles with diameters 3.5in./9 cm or larger. If the pole has a
smaller diameter, see previous mounting methods.
Required parts and tools:
Pole/wall mount bracket with attached pole clamps; see Section 6.3.1, “
Note
: When using straps on poles greater than 4 in./10 cm in diameter, pole clamps are not
required for the pole/wall mounting bracket.
Customer-provided steel straps and associated hardware
Slot head screwdriver or Phillips #2 screwdriver
To install the pole/wall mount bracket onto a vertical pole that is 3.5 in./9 cm in diameter or larger using
metal straps, refer to Figure 7, “Attaching Assemble Pole/Wall Mount Bracket to Pole with Straps” and
follow these steps:
1.
Assemble the two steel straps and the assembled pole/wall mounting bracket together by threading
the straps through the top and bottom strap slots of the bracket, respectively.
2.
Select a mounting location on the pole and place the steel straps with the assembled pole/wall
mounting bracket around the pole. Ensure the orientation cut-out is pointing up (see Figure 4,
“Pole/Wall Mount Bracket”).
3.
Position the pole/wall mounting bracket on the pole as needed and tighten the straps around the
pole with a slot head or Philips #2 screwdriver, as applicable. Ensure the steel straps are as tight as
possible.
Note
: Once the steel straps are tightened to full tension, the pole/wall mounting bracket cannot be
adjusted unless the straps are disassembled or cut.
4.
Install the HM or RBM onto the mounted pole/wall mount bracket. See Chapter 7, “Installing the
Hub Module” or Chapter 8, “Installing the Remote Backhaul Module”, as applicable.
Top View
