BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
15
Issue 01 D1
Figure 4 Pole/Wall Mount Bracket
Table 5 Recommended Torque Values for Self-Tapping Bolts
Item
Description
Torque
Note
1
Self-tapping bolts (x2)
27.1Nm or 20lbf-ft
—
To attach the two pole clamps to the pole/wall mount bracket, refer to Figure 5 and follow these steps:
1.
Place the pole clamps within the top and bottom of the pole/wall mounting bracket, aligning the
bolt holes of the clamps with those of the bracket.
2.
Use the socket wrench to lightly tighten the self-tapping bolts through the clamp holes into the
holes on the back of the bracket (do not over tighten).
3.
Use the torque wrench to tighten down the self-tapping bolts and finish the installation of the pole
clamps to the pole/wall mount bracket (do not over tighten). See Table 5 for torque values.
Note:
Pole clamps are not required for pole diameters greater than 4 in./10 cm.
Figure 5 Attaching Pole Clamps to Pole/Wall Mount Bracket
Front View
Back View
Self-Tapping
Bolts
Orientation
Cut-out (Up)
