BLiNQ Networks Inc.
X-1200 System Installation Guide
Release 1.0
Confidential - Restricted Use and Duplication
Page
12
Issue 01 D1
Uplink/downlink TDD ratio on the Hub
Preamble series index value
RF transmitter disabled on the HM (not transmitting)
Perform the following pre-installation checks and service provisioning on the HM and RBMs:
1.
Verify the modules can be powered up and Ethernet connectivity can be established.
2.
Verify and record the Media Access Control (MAC) address of each RBM unit (located on the label
on the outside of the unit).
3.
Using the X-1200 WebUI for HMs:
a.
Verify the configuration settings on the HM and update if necessary.
b.
Verify the active software version on the HM and upgrade if necessary.
c.
To allow the HM to go into service after installation, provision these HM radio operation
parameters through the ‘
Setup > Radio Interface Page
’ either before or after installation:
Radio Administrative State (set to ‘Enabled’)
RF Frequency
Max. Transmit Power
Preamble Phase Index (Optional)
Rate Adaption (Optional)
d.
(Optional) Provision these HM system parameters as needed through the ‘
Setup > System Page’
either before or after installation:
System Identification (including Name, Location, Contact, Description)
Ethernet Port Configuration
Management Interface IP Address
For more information, refer to the
X-1200 System User Guide
.
4.
Using the X-1200 WebUI for RBMs:
a.
Verify the configuration settings on each RBM and update if necessary.
b.
Verify the active software version on each RBM and upgrade if necessary.
c.
To allow the RBM to go into service after installation, provision these RBM radio operation
parameters through the ‘
Setup > Radio Interface Page
’ either before or after installation:
Radio Administrative State (set to ‘Enabled’)
d.
(Optional) Provision these RBM system parameters as needed through the ‘
Setup > System Page
’
either before or after installation:
System Identification (including Name, Location, Contact, Description)
Ethernet Port Configuration
Management Interface IP Address
For more information, refer to the
X-1200 System User Guide
.
