Blaze E6IO, Manual

Page: 17 / 48

17
INSTALLATION GUIDE
The location of the stubbed gas line port and electrical
pass through port for running the ignition cable are
determined during design. The location may either be
directly with the fireplace, or these components may
be remotely located nearby, but never in a location
to exceed 5’ length of ignition cable from the burner
itself.
Please refer to the specific component installation
manuals for the electronic gas valve, intermittent pilot
module, pilot assembly, and transformer supplied with
this fireplace and written by the manufacturer.
- Connect the ignition cable and other wiring to the
valve and direct intermittent pilot module as shown
below.
NOTE: These illustrations are not to scale and are for
reference only. For more detailed schematics, refer to
appropriate components in back of this manual.
Connecting the Gas Valve & Ignition System
IMPORTANT:
All connections and components should be made
and installed by qualified persons only and checked
and tested for leaks prior to wiring of valve module.
Gas supply should be connected as shown below.
Directions for Connecting a Gas Pressure Test Gauge
The gas control valve (shown to the right) has two test ports for testing input (line pressure)
and output (manifold) pressure. Loosen the brass screw on either test port and place a 5/16”
i.d. rubber or plastic tube over the tapered test port. Connect the tube to the test gauge.
WARNING: The brass screw must be tightened after testing to prevent gas leakage.
Input Port Output Port
SAMPLE