Blaze E6IO, Manual

Page: 4 / 48

4
INSTALLATION GUIDELINES:
- Acucraft does not install fireplace systems.
- Contact a licensed installer for proper installation.
Installation and repair should be done by a qualified
service person. The appliance should be inspected
before use and at least annually by a professional service
person. More frequent cleaning may be
required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments, burners, and circulating air
passageways of the appliance be kept clean.
L’installation et la réparation devrait être confiées à un
technicien qualifié. L’appareil devrait faire l’objet d’une
inspection par un technicien professionnel avant d’être
utilisé et au moins une fois l’an par la suite. Des nettoy -
ages plus fréquents peuvent être nécessaires si les tapis,
la literie, et cetera produisent une quantité importante de
poussière. Il est essentiel que les compartiments abritant
les commandes, les brûleurs et les conduits de circulation
d’air de l’appareil soient tenus propres.
Instructions are included for removal and re-installation of
the glass panels. Only tempered glass is certified for use
with this appliance. This fireplace is NOT
certified to be used without a glass front and sides. DO
NOT use if any portion or pane of glass is
broken, cracked, damaged, or otherwise visually flawed.
Contact a technician to replace the damaged panel imme -
diately.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
Ne pas se servir de cet appareil s’il a été plongé dans
l’eau, même partiellement. Faire inspecter l’appareil par
un technician qualifié et remplacer toute partie du système
de contrôle et toute commande qui ont été plongées dans
l’eau.
This appliance is not for use with glass doors.
Cet appareil ne peut être équipé de portes en verre.
SAFETY
SAFETY STATEMENTS:
Safety is very important and is referenced throughout
this manual in different ways. There are two different
safety levels that you should be aware of. Warning
statements will occur when there is a possibility of
bodily harm present. Caution statements will occur
when there presents a risk of damage to the unit if
the statements are not followed correctly. Below are
examples of what the statements look like.
This statement is used when
personal injury may result if
not followed properly.
WARNING
This statement is used when
equipment damage may
result if not followed properly.
CAUTION
INSTALLATION SAFETY CODES:
These instructions should be used as a guideline only, and
do not supersede local codes in any way.
Please check with local codes before installation.
In the absence of local codes, use the current
National Fuel Gas Code – ANSI Z223.1 (NFPA 54) or
CAN/CGA B149 Installation Code.
The appliance, when installed, must be electrically ground -
ed in accordance with local codes or, in the absence of
local codes, with the National Electrical Code, ANSI/NFPA
70, or the Canadian Electrical Code, Part 1 CSA C22.1.
Installed venting must conform to local codes or, in the
absence of local codes, to National Fuel Gas Code (AN -
SI-Z223.1) or to CAN/CSA-B149.1
SAFETY STATEMENTS:
Safety is very important and is referenced throughout this
manual in different ways. There are two different safety
levels that you should be aware of. Warning statements
will occur when there is a possibility of bodily harm pres -
ent. Caution statements will occur when there presents
a risk of damange to the unit if the statements are not
followed correctly. Below are examples of what the state -
ments look like.
SAMPLE