PI-1010A
Page 17
DATE PRINTED: 4/7/11
Version 1.05
Princess PI1010A INSERT STOVE INSTALLATION PROCEDURE
AFTER YOU READ AND FULLY UNDERSTAND THE MATERIAL IN THIS MANUAL, YOU ARE READY TO
PROCEED WITH THE INSTALLATION OF YOUR STOVE.
Before beginning the installation, thoroughly clean and inspect the fireplace and chimney you are using.
Professional assistance is recommended. Your local certified installer should be contacted to provide
installation and inspection services.
TOOLS NEEDED FOR INSTALLATION
If you are planning to install this stove yourself, you will need the tools listed below. Consult the chimney and flue
connector manufacturer's installation instructions for
tools
needed for chimney installation.
- 1/4" Wrench, Nut driver, or Socket with Handle.
- Medium Flat Blade Screwdriver, Phillips Screwdriver and #2 Square Drive Screwdriver
- Tape Measure.
- Carpenter's Level.
- METAL STRIPS (which are included with the stove), these can be used for sliding the unit into the fireplace opening.
See OPTIONS section for tools needed.
STOVE ASSEMBLY
Remove all items packed in the firebox.
IF YOU HAVE NOT ALREADY DONE SO, PLEASE TAKE A FEW MINUTES TO COMPLETE THE WARRANTY CARD
FOUND IN THE FIREBOX AND MAIL IT TODAY.
PRODUCT INSPECTION
BLAZE KING Stoves are known for their quality materials and construction, however, mistakes occasionally occur.
Inspect all parts for damage due to shipping and to be sure that all needed parts are enclosed. If you discover a part is
missing or damaged, contact your dealer immediately for replacement or repair. Refer to the part number listed on page
32 and the model and serial numbers of your stove (see the tag on the back of the stove).
COMBUSTOR ASSEMBLY, INSTALLATION
See page 26 for proper parts names. This stove is generally shipped from the factory with the combustor installed. If the
combustor is not installed, follow the instructions on page 27 under Catalytic Combustor replacement, beginning with
Step 6.
FLAME SHIELD, INSTALLATION
The flame shield is a stainless steel plate, punched with 3/8” holes. If the flame shield has fallen off during shipping then
it must be re-installed before the first fire. Hold it in the firebox with the triangular wings facing away. Lift it between the
loading door and the catalyst, resting the bottom of the plate on the two pins that protrude below the catalyst. The flame
shield should rest at an angle (about 45 degrees) with its bottom near the combustor, and its top near the stove front.
OPTIONAL ACCESSORIES
Gold Door—Part# Z4686G-C
REPLACEMENT PARTS
S e e
Preparation and Assembly
BEFORE YOU PUT YOUR STOVE IN PLACE,
YOU MUST ATTACH THE WARNING PLATE
INCLUDED WITH YOUR STOVE (SHOWN TO
THE RIGHT). THIS LABEL PLATE MUST BE
ATTACHED TO THE INSIDE WALL OF YOUR
FIREPLACE.
