Grinding & Polishing
MODEL BGS-250-115-S GRINDER
SECTION 5
INITIAL OPERATION
29
OPERATING MANUAL
FEBRUARY 2008
•
Put the grinding machine and the dust collector onto the surface to be
processed.
•
If you have not installed a diamond grinding disc, you have to install it
now. Please read Section 7 Maintenance of this manual.
•
Using the correct cables, connect the machine and the dust collector to
the electricity supply point. These electric supply points should be
protected and equipped with an Fl-switch. In case of doubt, ask the local
safety officer.
•
Check the extension cable for external damages.
•
Check the dust hose for damages.
•
Connect the grinding machine and the dust collector with the dust hose.
Use hose clamps at the connections.
•
Make sure the dust bin of the dust collector unit is empty.
•
Connect the electric cable of the dust collector with the supply.
Before start-up, the operating personnel must be familiar with the
safety regulations given in this manual.
If problems with the BGS-250-115-S arise during the assembly
or start-up, call a qualified person for help. Work on electrical
equipment may only be undertaken by qualified personnel
.
Any machine, if it is not used according to the regulations, may
be hazardous to the operating, set-up and service personnel.
The equipment owner is responsible for compliance with the
safety regulations during operation and maintenance of safety
devices supplied with the machine as well as the provision of
appropriate additional safety devices.
5.1 PREPARATION FOR INITIAL OPERATION
