Blade Nano CPS, Instruction Manual

Page: 7 / 68

7
EN
1. Lower the throttle and throttle trim to the lowest set-
tings.
2. Power on the transmitter.
3. Install the fl ight battery in the battery holder. Connect
the battery cable to the 3-in-1 control unit.
NOTICE: Do not allow the helicopter to move until the
blue LED on the 3-in-1 control unit is solid.
NOTICE: Always disconnect the Li-Po battery from the
3-in-1 control unit of the aircraft when not fl ying. Failure
to do so may result in over discharge.
Installing the Flight Battery
Transmitter Control (RTF)
F
G
H
E
A
D
C
B
Panic
Recovery
Flight mode
switch
A B C D E F G H
Mode 1
Power LED/
fl ight mode
indicator
Aileron (Left/Right)
Throttle (Up/Down)
Throttle
Trim Aileron
Trim ON/OFF
Switch Rudder
Trim Elevator
Trim Rudder (Left/Right)
Elevator (Up/Down)
Mode 2
Power LED/
fl ight mode
indicator
Aileron (Left/Right)
Elevator (Up/Down)
Elevator
Trim Aileron
Trim ON/OFF
Switch Rudder
Trim Throttle
Trim Rudder (Left/Right)
Throttle (Up/Down)
When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing. The middle or
neutral trim position is heard as a middle tone in the pitch range of the sounds. The end of the control range is sounded
by a series of beeps.
H B
Bind switch
Dual rate switch
Pa
R
Dual Rate Selection
The control sensitivity can be changed by pressing and releasing the right control stick. The LED on the transmitter will show
solid for high sensitivity (default) and fl ashing for low sensitivity.