www.miniraq.com
PAGE 6
Mounting to Concrete Wall with TAPCON® bolts
(Hole Pattern C)
Place the MiniRaQ
main back panel against the wall in the preferred location.
Refer to Figure 5 on Page 5 for correct mounting hole pattern.
Using integrated level, adjust panel and to level and mark a
of the two top,
two bottom and two middle 1/2” clearance holes (Hole C) Drill 5/32” pilot holes
for 3/16” bolts, or 3/16” for 1/4” bolts pilot holes as required by manufacturer.
Apply TAPCON® or equivalent concrete double threaded screws. A minimum
2 1/4” length is recommended for full rated loading of MiniRaQ.
Lift main back panel and hand tighten bolts and washers (not supplied) most of
the way into wall. Tighten all screws.
Next go to bracket installation details (pg 7).
(TM)
minimum
Mounting to Concrete Wall with Compression Lags (Hole Pattern C)
Place the MiniRaQ
main back panel against the wall in the preferred location.
Refer to Figure 5 on Page 5 for correct mounting hole pattern.
Using integrated level, adjust panel and to level and mark a
of the
two top and two bottom ½ inch clearance holes (Hole C) Drill marked holes as
required and apply compression studs or other associated inserts as required.
Lift main back panel and hand tighten bolts and fender washers (not supplied)
most of the way into stud. Tighten all screws.
Next go to bracket installation details
.
(TM)
minimum
(pg 7)
Warning
The MiniRaQ
must be properly installed to a suitable surface and using
recommended hardware per instructions provided.
Caution:
(TM)