www.miniraq.com
PAGE 4
Begin installing supplied
screws in pilot holes at the
top then drill and install
remaining screws in the
pattern. 10 screws
recommended for full
payload rating of system.
Locate solid studs, 16 inches on
center before marking top two
locations for pilot holes.
Drill .156” at the top using
the integrated level to locate
proper mounting pattern.
Close up detail of
16” Center to Center
Mounting option
Mounting into 16 inches on center
solid wood wall studs (Hole Pattern B)
Place the MiniRaQ(TM) main back panel
against the wall in the preferred location.
Confirm location of stud centers and for
at least one TOP pilot hole. Drill pilot
hole using 5/32” bit (not supplied).
Place the first #10 wood screw through
top slot B and insert screw most of the way
into stud. Using integrated level, adjust
panel and drill remaining TOP Pilot hole
and insert screw most of the way into stud.
All remaining pilot holes can be drilled and
screws inserted into holes as above.
Tighten all screws.
Next go to bracket installation details
.
(pg 7)
FIGURE 4