www.miniraq.com
PAGE 5
An approved hollow wall application is considered to be either of the following;
Cinder Block wall or NEC type 3/4” plywood electrical panel backing using
toggle bolts is safe for full rated load of MiniRaQ
System.
In the event that this bracket is to be mounted on a block wall 1/4” x 3” toggle
bolts should be used to support it. It will be important that the hollow pocket
in the block is located so that the toggle can open properly to support the
weight. Toggle bolt clearance hole is 1/2” (bolts and washers not supplied;
available for purchase separately).
(TM)
Mounting to Cinder Block or Approved Hollow Wall (Hole Pattern C)
Place the MiniRaQ
main back panel against the wall in the preferred location.
Using integrated level, adjust panel to level thenmark a
of the two
top and two bottom ½ inch clearance holes (Hole C). Drill marked holes and apply
Togglers® or other associated inserts as required. Lift main back panel and hand
tighten bolts and fender washers (not supplied) most of the way into stud.
Tighten all screws.
Next go to bracket installation details
.
(TM)
minimum
(pg 7)
Note
!
Note
!
This Illustration shows recommended
mounting pattern for concrete screws
with fender washers
FIGURE 5