Part
II:
Setting Up
The
Log
Splitter
8
instructions.
Make sure all bolts and nuts are fitted
correctly and tightened when assembling the machine.
When opening the wooden box, beware of sharp edges on
the closing mechanisms.
Please observe the following when beginning machine
assembly:
-
Clear the area of nearby persons, particularly
children.
-
Use a forklift or similar device to move or lift the
pallet/machine.
-
Keep the load close to the ground.
-
Move the machine to the assembly site.
-
Ensure there is enough room to safely assemble the
machine and access the machine from all sides.
1.
Removing the transport packaging
Remove the transport packaging as shown in Figures 1 to 4
(may vary).
Read the entire assembly instructions
BEFORE! assembling the wood chipper
and familiarise yourself with the
individual assembly steps!
Fig. 2 Attaching the arm
PART III: Assembly instructions
The machine is delivered from the factory in
the
transport
configuration.
Always
use
tools,
appliances,
and
lifting
equipment
of
suitable
size
and
po
wer
for
assembly.
2
people are always required to lift, move, and
assemble
the
machine.
Wear
adequate
protective clothing such as safety shoes and
protective gloves. Please observe the safety
precautions
specified
in
“General
Safety
Instructions”
chapter
of
these
operating
Fig. 1 GTS-2000 inside transport packaging
Summary of Contents for GTE-2000
Page 1: ...GTE 2000 WOOD CHIPPER Instruction Manual Table of Contents ...
Page 3: ...Part I GeneralSafety Rules 2 Safety Labels Found on Your Unit ...
Page 16: ...Part II Setting Up The Log Splitter 15 tighten the plate again using the four bolts ...
Page 24: ...x Part II Setting Up The Log Splitter 23 Fig 63 Open choke and fuel shut off Choke Fuel tap ...
