Part
II:
Setting Up
The
Log
Splitter
13
Fig. 21 Setting cover aside
6.
Checking the alignment of the belt pulleys
Check the alignment of the belt
pulleys using a level or gauge. The
belt pulleys must be positioned on top
of each other in a vertical and parallel
manner.
If
this is not the case, slightly loosen
the bolts on the engine and shift the
engine on the housing, to adjust the
belt pulley correctly and flush. This is
important because otherwise, the V-
belts do not correctly correspond to
their function and can wear quickly.
If the alignment is correct, tighten the
bolts again. Bear in mind that the
engine block is made of aluminium
and the bolts should not be
tightened
too severely
.
Fig. 22 Grease nipple shaft belt pulley
Fig. 24 Proper alignment
Vertical !
Parallel !
Fig. 25 Loosen slightly
Fig. 19 Loosening bolts on the left
Fig. 23 Grease nipple shaft on the left
Summary of Contents for GTE-2000
Page 1: ...GTE 2000 WOOD CHIPPER Instruction Manual Table of Contents ...
Page 3: ...Part I GeneralSafety Rules 2 Safety Labels Found on Your Unit ...
Page 16: ...Part II Setting Up The Log Splitter 15 tighten the plate again using the four bolts ...
Page 24: ...x Part II Setting Up The Log Splitter 23 Fig 63 Open choke and fuel shut off Choke Fuel tap ...
