Black Tools GTE-2000, Instruction Manual

Page: 29 / 32

Part V: Troubleshooting and Parts List
28
PART VI: Troubleshooting and Parts List
Most problems are easy to fix. Consult the Troubleshooting Table below for common problems
and their solutions. If you continue to experience problems, contact the dealers in your area.
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes
to allow all parts to cool. Disconnect the spark plug wire, keeping it away from the spark plug.
Troubleshooting Table
SYMPTOM POSSIBLE CAUSE
The engine won’t start.
(Please refer to the
engine user manual for
engine-specific
procedures.)
¾ Is the ignition switch in the “ON” position?
¾
Is the fuel shut-off valve on?
¾ Are you using fresh, clean gas? If the gas is old, change it. Use
a fuel stabilizer if you keep gas longer than 30 days.
¾ Is the spark plug clean? If the spark plug is dirty or cracked,
change it. If it’s oily, leave it out, hold a rag over the plug hole and
pull the recoil cord several times to blow out any oil in the cylinder,
then wipe off the plug and reinsert it.
The engine lacks power or
is not running smoothly.
(Please refer to the
engine user manual for
engine-specific
procedures.)
¾ Check that the Throttle Lever is in the “Run” position.
¾
Is the air filter clean? If it’s dirty, change it following the procedure
in the engine manufacturer’s owner’s manual.
¾ Is the spark plug clean? If it’s fouled or cracked, change it. If it’s oily,
leave it out, hold a rag over the plug hole and pull your recoil cord
several times to blow out any oil in the cylinder, then wipe off the
plug and reinsert it.
¾ Are you using fresh, clean unleaded gas? If it’s old, change it. Use a
fuel stabilizer if you keep gas longer than 30 days.
¾ Does your engine have the r ight amount of clean oil? If it’s dirty,
change it following the procedure in the engine manufacturer’s
owner’s manual.
¾ Check the oil level and adjust as needed.
WARNING