SPITFIRE 40.
22
mounting area. Apply epoxy to the bottom and
top edges of the filler block and to the lower
hinge also. Set the stabilizer in place and re-
align. Double check all of your measurements
once more before the epoxy cures. Hold the
stabilizer in place with T-pins or masking tape
and remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the epoxy to
fully cure before proceeding.
Expoxy glue.
Rudder control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
C/A glue.
3mm x 40mm.
M3 lock nut
.
Nilon
control clasp.
RUDDER CONTROL HORN INSTALLATION.
Remover covering.
C/A glue.
Drill 6mm diameter a hole of the mounting
rudder control horn on to the rudder.
CONTROL HORN OF RUDDER
.
Mark point.
