INSTRUCTION MANUAL.
7
1) Insert the 90º bend of one main gear
wire into the predrilled hole in one mounting
slot.
2) The landing gear wire is held in place
using two nylon landing gear straps and four
3mm x 12mm wood screws.
The straps should be located equal distance
from the inside and outside ends of the wire.
Remove covering.
INSTALLING THE LANDING GREAR.
3 x 12mm
.
Nilon Strap.
4) Remove the two straps and the gear
wire. Drill four 1.5mm pilot holes into the wing
for the wood screws.
Be careful not to drill
through the top of the wing!
3) Using the two landing gear straps as a
guide, mark the locations of the four 3mm x
12mm mounting screws onto the wing sur-
face.
5) Reinstall the gear wire and install the
straps using the four 3mm x 12mm wood
screws. Tighten the screws completely to
secure the gear wire in place.
7) Slide one 60mm diameter wheel onto
each axle and push them up against the wheel
collars. Slide the remaining wheel collars with
4.3mm x 6mm set screws onto the axles.
Push them up against the wheels and tighten
the set screws. The wheels should spin free
and not bind in any way. If they do bind, loosen
the set screws in the outer wheel collars and
move the collars out a small amount. Re-
tighten the set screws.
6) Slide one wheel collar with 4.3mm x
6mm set screw onto each axle. Push the
wheel collars on as far as they will go and
tighten the set screws.
Be careful not to overtighten the set screws.
Overtightening may cause the threads to strip.
