SPITFIRE 40.
4
INSTALLING THE AILERON CONTROL HORN.
Repeat the procedure for the other wing
half
.
Wing.
Servo tray.
4) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
5) Install servo tray with aileron servo into
the wing as same as picture below.
Servo wire.
Control horn of aileron.
3x40mm.
Nilon control clasp.
M3 lock nut.
2) Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into aileron
servo tray as same as picture below:
3) Using a modeling knife, remove the
covering at possition show below.
Aileron servo tray.
Top of wing.
Remove the covering.
C/A glue.
