724-746-5500 | blackbox.com
Page 23
Chapter 6: Operation
Figure 6-7. Press the down arrow button
q
after cable is connected.
Follow the instructions. Only an uncoiled cable will give you
accurate test results. At this point in the testing, the far end of
the cable should not be connected to any device.
NOTE: If the cable is connected to a device, you will be alerted to
check the far end of the cable. When ready to proceed, press
the down arrow (
q
TEST).
Error Messages: If there is a problem that stops the test from
proceeding, one of the following error messages will be
displayed:
CABLE IS ACTIVE: There is an active network port on the far end
of the cable. You will need to unplug it to proceed.
CHECK CABLE END: A voltage is present on one or more of the
cable pairs, or the Remote Probe is connected to the cable end
when it is not needed. You will need to unplug it to proceed.
NO CABLE: There is no cable connected or an inactive port is
plugged into the far end of the cable.
NOTE: If errors persist from test to test, contact Black Box
Technical Support at 724-746-5500
or [email protected].
