53
CHAPTER 6: Operation
d.
Set the Card to duplexing mode through the printer’s front panel.
The available selections are “no duplexing,” “long-edge,” and “short-
edge” (tumble).
e.
Set the Card to duplexing mode through host/PC-download
command 33. The possible arguments are:
0 = simplex;
1 = duplex, long-edge; and
2 = duplex, short-edge
(tumble)
Type “&%Z33,1” or “&%Z33,2” into the document or on the screen
and print the document or the screen to set the Card to duplex
printing (long-edge or short-edge respectively). To return to simplex
printing, type and print “&%Z33,0”.
For some duplex printing, if the last page is blank on the back side, the
information for the last page may remain in the printer until the next print job
is received. If you want to print the last page, take the printer off line by
pressing the ONLINE button, then press the FORM FEED button to print the
last page. Put the printer back on line by pressing the ONLINE button again.
6.8 Other Print Commands
You can also enter commands into your document that let you control true
LPI and response to host commands. These commands, listed in Table 6-2
below, are similar to font-change and duplex-printing commands.
The ¬E command lets you send an escape command to the printer to
control the printing. For example, “¬E(s3B” would begin bold printing (see
your printer’s manual for a list of the printer’s escape commands).
The printer may compress line spacing to fit 66 lines onto the page. This
may be undesirable, for example when you use preprinted forms that must
align correctly. In these cases, the ¬TY command prevents the printer from
compressing the line spacing.
Use the ¬I and ¬S commands to remove unwanted host commands from a
print file. For example, when printing with forms-generating software, the
files are recognized by the host as text files and formatted with unwanted
carriage returns and line feeds. Placing the ¬I at the end of a line and ¬ S
at the front of the next line causes the Card to remove the host’s carriage-
return and line-feed commands and send only the data to the printer.
