104
HPIIISi TWINAX CARD
8.6 Problem-Resolution Guide
Table 8-2. Typical Problems.
Problem or Message
Probable Cause
Action
“Printer not ready”
Printer not in a ready
Make sure the printer
message at host.
status.
is on line, has
paper, etc.
Printer loses host
Improper or damaged
Check twinax
communication (drops
cabling.
cabling for
off line).
improper
connections or
damage.
Twisted-pair cabling is
See
Section 8.1
.
not attached to an
“active” or boosted
hub.
Right margin is cut off.
Page width in word-
Change to a wider
processing program is
page.
not set wide enough.
Page is too wide.
Select a narrower
page.
Extra blank sheets are
Form length not
Make sure your
ejected between sheets
correct in software
document length
of printout.
(maximum length is
doesn’t exceed the
66 lines).
maximum number
of lines.
Page orientation was
The printer may
changed.
eject a blank page
when the page
orientation (portrait
or landscape) is
changed.
