724-746-5500 | blackbox.com
Page 168
Chapter 5: Configuration
Parameter description:
• Port: The port number for which the configuration below applies.
• Enabled: Controls whether the storm control is enabled on this switch port.
• Rate: Controls the rate for the storm control. The default value is500. This value is restricted to 100–1000000 when the “Unit”
is “kbps” or “fps,” and it is restricted to 1–10000 when the “Unit” is “Mbps” or “kfps.”
• Unit: Controls the unit of measure for the storm control rate as kbps, Mbps, fps or kfps. The default value is “kbps.”
• Buttons:
Apply: Click to apply changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
5.15.13 WRED
The section allows user to configure the WRED function for the switch. This page allows you to configure the Random Early
Detection (RED) settings for queue 0 to 5.
RED cannot be applied to queue 6 and 7.
Through different RED configuration for the queues (QoS classes) it is possible to obtain Weighted Random Early Detection
(WRED) operation between queues.
The settings are global for all ports in the switch stack.
The displayed settings are:
Web Interface
To configure the WRED Configuration parameters in the web interface:
1. Click Configuration, WRED Configuration
2. Evoke to select enable or disable WRED
3. Key-in each Parameter value.
4. Click the apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 5-86. WRED Configuration screen.
