724-746-5500 | blackbox.com
Page 14
Chapter 2: Introduction
Table 2-1. Supported SFP Transceivers.
Product Code
Description
LFP401
SFP, 155-Mbps Fiber with Extended Diagnostics, 850-nm Multimode, LC, 2 km
LFP402
SFP, 155-Mbps Fiber with Extended Diagnostics, 1310-nm Multimode, 2 km, LC
LFP403
SFP, 155-Mbps Fiber with Extended Diagnostics, 1310-nm Single-Mode, Plus, 30 km, LC
LFP411
SFP, 1.25-Gbps Fiber with Extended Diagnostics, 850-nm Multimode, LC, 300 m
LFP412
SFP, 1.25-Gbps Fiber with Extended Diagnostics, 1310-nm Multimode, LC, 2 km
LFP413
SFP, 1.25-Gbps Fiber with Extended Diagnostics, 1310-nm Single-Mode, LC, 10 km
LFP414
SFP, 1.25-Gbps Fiber with Extended Diagnostics, 1310-nm Single-Mode, LC, 30 km
LSP421
10GBASE-SR SFP+, 850-nm Multimode, 300 m, LC
LSP422
10GBASE-SR SFP+, 1310-nm Single-Mode, 10 km, LC
2.4.3 Port and System LEDs
The Gigabit PoE+ Ethernet Managed Switch Eco switch includes a display panel for system and port indications that simplify
installation and network troubleshooting. The LEDs are located on left-hand side of the front panel for easy viewing. Details are
shown below and described in the following tables.
Table 2-2. Port Status LEDs.
LED
Condition
Status
TP (Link/ACT)
Green/Blinking
Lights Green when TP link is good.
Blinks when any traffic is present.
TP SPEED
Green/Yellow
Lights Green when TP link on 1000 Mbps.
Yellow when TP link on 10/100 Mbps.
PoE (Link/ACT)
Green
Lights Green when PoE links with PD and supplies power to PD.
SFP (Link/ACT)
Green/Blinking
Lights Green when SFP link good.
Blinks when any traffic is present.
SFP SPEED
Blue/Green
Lights Blue when SFP link on 10Gbps.
Green when SFP link on 1000Mbps
Table 2-3. System Status LED.
LED
Condition
Status
System LED
Green, OFF
Lights when power is on and the switch is ready.
2.4.4 Power Supply Socket
The power socket uses an AC power cord and is located on the rear panel of the switch. See Figure 1-2.
