REMOTE VIDEO SYSTEM IP
48
• At the bottom of the page are checkboxes for the SNMP traps that can be used: authentication failure,
login, cold start, and link up traps.
4.3.10 C
ONFIGURE
S
ECURITY
F
EATURES
On the security page, you can specify the authentication information required for logging on to the RVS
device.
For the Remote Video System IP, by default there is no password authentication. If you are accessing the
Remote Video System IP by opening the Web user interface or issuing a “telnet” command, no login prompt
appears. If desired, you can enable password authentication. After changing the user name or password, you
will immediately be asked to log back in to the Web interface using the new values.
To further secure your Remote Video System IP, you might want to disable those network services not necessary
to the device or turn off any non-secure network services such as Telnet. See
Section 6.2
.
4.4 Configuration Through the Command Line
Configuring Remote Video System IPs through the Command-Line Interface consists of entering a series of
commands to set values in the device. The RVS Connect Family Command Reference describes the commands
used to configure, monitor, administer, and operate RVS Connect devices.
4.4.1 A
CCESSING THE
C
OMMAND
L
INE
To configure devices using commands, you must first access the command line. You can either launch the
Command-Line Interface from the last page of the RVS Device Setup Wizard or using the “telnet” command.
Enter the “telnet” command from a command prompt on another networked device, such as a server, as
follows:
telnet
ip-address
where ip-address is the IP address of the Remote Video System IP. For example:
telnet 192.3.23.5
If security is enabled for the Remote Video System IP, (that is, a username and password have been set up for
logging on to it), a login prompt is displayed. If you do not know the user name and password for the device,
contact the system administrator who originally configured the device.
4.4.2 V
ERIFYING
W
HICH
C
OMMANDS ARE
S
UPPORTED
To verify whether a Remote Video System IP Display supports a particular command, online help is available.
For example:
• “help” displays all supported commands for a device.
• “?” displays all supported commands for a device.
• “set ?” displays the syntax and options for the “set” command. You can use this command to determine
whether the device includes a particular “set” command variant.
• “help set” displays syntax and options for the “set” command.
Summary of Contents for AC1059A
Page 3: ......
