20 • ENGLISH
MAINTENANCE
Cleaning
Warning!
Blowing dust and grit out of the motor housing
using compressed air is a necessary maintenance procedure.
Dust and grit from metal grinding often accumulate on interior
surfaces and could create an electrical shock hazard if not
cleaned out.
Warning! Always
use safety glasses. Everyday
eyeglasses are
Not
safety glasses. Also use face or dust
mask if operation is dusty.
Always wear certified safety
equipment.
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Important!
To assure product
Safety
and
Reliability,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always
using identical replacement parts.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your Black & Decker product
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service. For
more information about our authorized service centers and
if you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest you, or visit us at
www.BlackandDecker-la.com
SPECIFICATIONS G900/G900K
Voltage
B3 120V
Power 900W
No-load speed n
0
11000/min
Disc diameter 4 - ½" (115mm)
Disc bore 22mm
Spindle size 5/8"-11 / M14
PROBLEM
Unit will not start.
CAUSE
1. Cord not plugged in.
2. Circuit fuse is blown.
3. Circuit breaker is tripped.
4. Cord or switch is damaged.
SOLUTION
1. Plug tool into a working outlet.
2. Replace circuit fuse. (If the product
repeatedly causes the circuit fuse to
blow, discontinue use immediately
and have it serviced at a Black &
Decker service center or authorized
servicer.)
3. Reset circuit breaker. (If the product
repeatedly causes the circuit
breaker to trip, discontinue use
immediately and have it serviced at a
Black & Decker service center or
authorized servicer.)
4. Have cord or switch replaced at a
Black & Decker service center or
authorized servicer.
TROUBLESHOOTING
