• Clean the spray nozzle, pickup tube and
filter, atomizer, piston and spring with the
cleaning brush in the appropriate cleaning
solution (
figure K8
).
•
Thoroughly
clean the inside of the piston
chamber with the cleaning brush (
figure K9
).
IMPORTANT:
Be sure to remove all material
from inside of piston chamber. A small amount
of material that is not removed with the
cleaning brush can harden over time and
interfere with the movement of the piston
causing damage to the sprayer.
•
Thoroughly
clean the inside of the intake
and return openings with the cleaning brush
(
figure K10
).
IMPORTANT:
Also thoroughly clean the
smaller vent hole, shown with an arrow in
figure K11
, with included cleaning pin.
• Dry all parts thoroughly.
REASSEMBLY
• Slide the spring onto the front of the piston
(
figure L
).
• Insert the piston and spring into the front
housing (
figure L1
).
• Pressing down on the release button, insert
the front housing with piston, into the sprayer
until the release button pops into place
(
figure L2
).
NOTICE: The unit will not reassemble with-
out the piston and spring in place.
• Place a few drops of oil through the cylinder
opening. Insert the atomizer valve into the
front housing. Thread the spray nozzle onto
the front housing and hand tighten (
figure L3
).
12
K10
K8
K9
L1
L
L2
L3
K11
