bk ultrasound Flex Focus 1202, User Manual

Page: 47 / 66

Flex Focus 1202 User Guide (BB1756-Q) Battery Support 47
Chapter 4
Battery Support
This chapter is only relevant if your system has battery support.
The battery pack enables you to operate the system while it is not connected to an
external electrical supply.
Before You Start
Be sure to read the battery support warnings (warnings with BS numbers) in “Battery
Support System” on page 29. Also note the following:
Plug imaging
system into
wall before
inserting
batteries
NOTE:
To ensure that batteries charge properly, you MUST connect the power supply
cord to the line voltage BEFORE you insert any batteries in the battery pack.
Be sure to read the rest of this chapter before you use the battery support system.
To configure and customize the battery pack’s operation, see Flex Focus Advanced
User Guide .
Imaging with Battery Support
This is an overview of the steps for using the battery support system to power the
imaging system.
1
Make sure the batteries are charged.
(If not, plug in the imaging system to use it or to change the batteries.)
2
Turn on the system.
3
When the batteries run down, you do not have to turn off the imaging system.
Either
•
plug it into the wall to recharge the batteries while you run on power from the
normal power supply
or
•
plug it into the wall, change the batteries (see “Changing or Replacing a Battery”
on page 52), unplug from the wall and run on battery power again.
If you have an extra set of batteries that you charge with a battery charger station
(UA1247), you can always have charged batteries ready to insert when needed.
Battery Pack Location
The battery pack is located in the bottom drawer of the backpack on the mobile
battery keyboard dock.