Integral Operation Function
41
q type
used for selecting the current integration mode. Options of the current integration mode are as
follows:
rms
Effective value;
mn
Calibration to the average rectified value of the effective value.
dc
Simple averaging;
rmn
Average rectified value;
ac
AC component
7.4 Integration
When the integral measurement function is enabled, you can keep the current integral information and carry out the
following operations: exit, start and stop. Specific steps are as follows:
Operation steps
1. Press “Integ” to enter the integral display interface.
2. In the integral measurement display interface Press the soft key corresponding to the “START” parameter to start or
recover integral operation. The Start status and integral operation value are displayed in the interface.
3. When you need to keep the current integral status and integral result, you can press the soft key corresponding to
the “RUN HOLD” parameter. Then the current status of the integral result display and communication output will
be kept no matter whether integral operation is running.
4. When you need to continue to implement integral operation, double-press the soft key corresponding to the “RUN
HOLD” parameter to exit the HOLD status. The power meter will display the integral result after exiting the HOLD
status. The schematic diagram of display of the HOLD/RUN integral result is shown below.
5. When you need to suspend integral operation, press the soft key corresponding to the “Stop” parameter to suspend
integral operation.
6. Press the soft key corresponding to the “RESET” parameter to reset the integral value and integral time. The
relationship diagram of start, suspension and resetting of the integral operation status is shown below.
Auto Clear
when ON is selected.
Auto Clear
when OFF is selected.
