BK Precision 4060B Series, Programming Manual

Page: 15 / 28

Common Command Introduction 15
Query Response <parameter> ={Return all parameters of the current sweep wave.}
Example Set channel one sweep time to 1 S.
C1:SWWV TIME, 1
Set channel one sweep stop frequency to 1000 Hz.
C1:SWWV STOP, 1000
Read channel one sweep parameters of which STATE is ON.
C2:SWWV?
Return:
C2:SWWV STATE, ON, TIME, 1S, STOP, 100HZ, START,
100HZ, TRSR, MAN,TRMD, OFF, SWMD, LINE, DIR, UP,
CARR, WVTP, SQUARE,
FRQ, 1000HZ, AMP, 4V, OFST, 0V, DUTY, 50, PHSE, 0
Read channel two sweep parameters of which STATE is OFF.
C2:SWWV?
Return:
C2:SWWV STATE, OFF
2.16 Burst Wave Command
Description Sets or gets burst wave parameters.
Command Syntax <channel>={C1, C2} <parameter>={a parameter from the table below}
Note: If you want to set CARR and STATE, the first parameter has to one of them
where: <state>={ON, OFF}
<period>={Default unit is “S”. Value depends on the model.}
<start phase>={0 to 360}
<gate ncycle>={GATE, NCYC}
<trigger source>={EXT, INT, MAN}
<delay>={Default unit is "S", Value depends on the model.}
<polarity>={NEG, POS}
<trig mode >={RISE, FALL, OFF} <edge>={RISE, FALL} <circle time> ={Value depends
on the Model (“INF” means infinite).}
<wave type>={SINE ,SQUARE, RAMP, PULSE, NOISE, ARB}
<frequency> ={Default unit is "HZ". Value depends on the model.}
<amplitude>={Default unit is "V". Value depends on the model.}
<offset>={Default unit is "V". Value depends on the model.}
<duty>={0% to 100%.}
<symmetry> ={0% to 100%}
<phase>={0 to 360}
< standard deviation >={Default unit is "V". Value depends on the
model.}
<mean>={Default unit is "V". Value depends on the model.}
<width> ={Max_width < (Max_duty * 0.01) * period and
Min_width > (Min_duty * 0.01) * period.}
<rise>={Value depends on the model.}
<fall>={Value depends on the model.}
<delay>={Default unit is “S”.}
Note: There are some parameters Value depends on the model, You can read version
datasheet to get specific parameters.