BK Precision 4060B Series, Programming Manual

Page: 16 / 28

Common Command Introduction 16
2.16.1 Paramters
Parameters Value Description
STATE <state> Turn on or off burst. Note: If you want to set orread
other parameters of burst, you must set state to ON
at first. And when trigger source is EXT, you can’t
set it.
PRD <period> Value of burst period. When carrier is NOISE wave,
you can’t set it.
STPS <start phase> Start phase of carrier. When carrier is NOISE or
PULSE wave, you can’t set it.
GATE_NCYC <gate Ncycle> Set the burst mode to GATE or NCYC. When ca
rrier is NOISE, you can’t set it.
TRSR <trigger source> Set the trigger source.
DLAY <delay> Value of delay. When carrier is NOISE wave, you
can’t set it. When NCYC is chosen you can set it.
PLRT <polarity> Value of polarity. When GATE is chosen you can set
it. When carrier is NOISE, it is the only parameter.
TRMD <trig mode> Value of trigger mode. When carrier is NOISE wave,
you can’t set it. When NCYC is chosen you can set
it. When TRSR is set to EXT, you can’t set it.
EDGE <edge> Value of edge. When carrier is NOISE wave, you
can’t set it. When NCYC is chosen and TRSR is set
to EXT, you can set it.
TIME <circle time> Value of Ncycle number. When carrier is NOISE
wave, you can’t set it. When NCYC is chosen you
can set it.
MTRIG <manual trig> Manual trigger. When TRSR is set to MAN, it can
be set.
CARR,WVTP <wave type> Value of carrier type.
CARR, FRQ <frequency> Value of carrier frequency
CARR, AMP <amplitude> Value of carrier amplitude.
CARR, OFST <offset> Value of carrier offset.
CARR, SYM <symmetry> Value of symmetry. Only Ramp can set this
parameter.
CARR,DUTY <duty> Value of duty cycle. Only Square or Pulse can set
this parameter.
CARR, PHSE <phase> Value of carrier phase.
CARR, RISE <rise> Value of rise edge. Only when carrier is Pulse, the
Value is valid.
CARR, FALL <fall> Value of fall edge. Only when carrier is Pulse, the
Value is valid.
CARR,STDEV <standard deviation > Value of standard deviation. Only when carrier is
Noise, the Value is valid.
CARR,MEAN <mean> Value of mean. Only when carrier wave is Noise, the
Value is valid.
CARR,DLY <delay> Value of delay. Only whencarrier is Pulse, the
parameter is valid