160
Figure 142 - Send wave dialog
6.
Click the Store location area and select the location to store the waveform in the oscilloscope.
7.
Click the Send button. The oscilloscope will display the message “Saving waveform data,
please wait…”.
8.
When saving is complete, the oscilloscope will display “Waveform saved successfully”. Then
it will enter the WAVEFORM menu, the Wave Type will be set to ArbX (X is an integer between
1 and 4) to the "Store location" chosen in the window above.
Figure 143 - AWG menu
9.
To delete the arbitrary waveform, press the Delete softkey.
10.
Press the Setting softkey to enter the SETTING menu.
11.
Press the Output Load softkey to select high impedance (High-Z) or 50 Ω.
17.3
Output Impedance
1.
Press the Wave Gen button to enter the WAVEFORM menu.
2.
Press the Setting softkey to enter the SETTING menu.
3.
Press the Output Load softkey to select high impedance (High-Z) or 50 Ω. The impedance
selection will be shown on the top line of the display next to Awg.
Note: The output impedance of the generator must match that of the oscilloscope or the amplitude of the
signal will be incorrect.
