Bizerba VS 12 F--P, Operating Instructions Manual

Page: 62 / 79

Maintenance Operating instructions VS12 /C /F /F-P /W
8 - 16
6.080.98.5.10.13
en
8
Fig. 58: Handwheel marking
Switch on machine.
Set handwheel marking to "1".
The sharpening stone is engaged.
Sharpen until right blade edge shows a
burr.
Set handwheel marking to "0".
Switch machine off, wait until blade
stops rotating.
Checking burr:
Using a pen or pencil, touch the right edge of the blade while moving the pen from
inside to outside.
Burr must be noticeable, otherwise the sharpening procedure must
be repeated.
8.6.5 Honing
Fig. 59: Handwheel marking
Start blade motor.
Set handwheel marking to "2".
The honing stone is engaged.
Hone until a honing bevel of about 0.5 -
1 mm can be seen on the right blade
edge (after about 3-4 seconds)
Set handwheel marking to "0".
Switch machine off, wait until blade
stops rotating.
8.6.6 Removing sharpener
Pull sharpener back after loosening the star grip screw and remove to the top.
Set slice thickness immediately to "0".