Bizerba VS 12 F--P, Operating Instructions Manual

Page: 60 / 79

Maintenance Operating instructions VS12 /C /F /F-P /W
8 - 14
6.080.98.5.10.13
en
8
WARNING Missing components!
The operator can only be protected from injuries and the machine
protected against damage if all the components of the machine are
assembled properly.
– Check if the machine is complete before it is re-started.
– Check if components are positioned correctly and firmly.
– Only use original Bizerba spare parts and accessories.
8.6 Blade sharpening
Re-sharpening is necessary if the slicing result is unsatisfactory.
The time intervals are dependant on the wear and tear of the blade and/or its operating
usage as also the properties and conditions of the product.
If there is an annular gap greater than 6 mm between the blade and the
guard ring, the effect of the sharpener deteriorates and the blade has to
be replaced by Bizerba Customer Services.
8.6.1 Sharpener
The sharpener identified by the machine number has been adjusted for this machine.
The device is fitted with a coarse sharpening stone and a finely grained honing stone. Dirty
or greasy sharpening stones do not sharpen well.
Before sharpening, clean with brush and solving detergent.
If sharpening stones are worn, replace stones.
Replacement parts are supplied by Bizerba customer services.
When replacing, do not confuse sharpening and honing stones.
8.6.2 Preparation for sharpening
Remove parts and clean machine. See chapter 8.1 and the following.
Place paper felt or thin cardboard on carriage and cut off a few strips in order to en-
tirely remove grease from blade.
Switch off machine.
Remove the paper felt.
Tilt deflector away from blade.