Bivocom TG452 Series, User Manual

Page: 29 / 49

3.4.2 L2TP
You can also configure either L2TP client or L2TP server, but not both of them at the same
time, as that may cause uncertain issues.
1) L2TP Client
1. L2TP Client
You can enable or disable L2TP client.
2. Server Address
To enter the IP address or Domain Name of L2TP server.
3. User Name and Password
To enter the user name and password provided by server.
4. Remote Subnet
To enter the remote subnet, for example, if LAN of L2TP server is 192.168.2.1, then you
can enter remote subnet 192.168.2.0.
5. Remote Subnet Mark
To enter the remote subnet mask, normally it is 255.255.255.0.
6. NAT
If click NAT, all packets come from ppp0, and the source IP of the packets will be replaced
as IP of ppp0.
7. Enable MPPE Encryption.
You can enable MPPE encryption here.
8. Default Gateway
Click Default Gateway, then a default route will be established under ppp0, and all the data
will go through this route.