11
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
connection is active and the device is connected to a remote server; LED
slowly flashes for 0.2 seconds when GPRS connection is not active, and
the modem is in sleep mode.
LED “GNSS” (
green
) flashes (or lights) when the device is
receiving correct position coordinates and is off when the device is not
receiving the coordinates, or the signal is too weak, and the data are not
correct.
Adjustment of “BI-530P TREK” device
Basic information
The tracking device “BI-530P TREK” can be configured in following
ways:
1. With a direct connection of the device to a computer.
2. Remotely, using SMS commands.
3. Remotely, using the configuration server.
Setting of the device through any of the available methods is
limited with the setting of the required values of the device parameters.
Each parameter has its own unique ID. Special commands are used to
read/record the values of selected parameter.
At remote configuration via SMS take into consideration that the
total length of the SMS shall not exceed 160 Latin characters. Number of
commands in SMS is limited to a maximum length of SMS.
All commands for the device are divided into control and
information commands.
List of information commands to operate the device
Table 3 – List of information commands to operate the device “BI-530P
TREK”
No.
Command
Description
Availability
of response
1
getstatus
Information about current state of
the device
yes
2
getgps
Current GPS coordinates and time of
device.
Yes
3
getmap
Request of device coordinates
yes
4
getver
Request of the version of the device
software
yes
5
getio
Read the value of the device’s
internal sensors
yes
6
flush
Request of device profile parameters
yes
7
getparam
####
Read the value of the parameter by
its ID
yes
Notes to Table 3.
