10
www.bitrek.com.ua
[email protected]
+380 44 507 02 07
the device. Procedure of connection of USB-UART converter cable is
shown in Figure 4.
Connect the cable of USB-UART converter to the tracking device so
that the arrow on the cable socket to be located closer to the SIM-card
slot (see Figure 4).
To work with the USB-UART converter, install the appropriate
device drivers. They can be downloaded from the official website:
To exchange data with the device, use a terminal program. Settings
of the terminal: speed – 115200 bit/second, data bit – 8, stop bit – 1, no
parity check, no flow control.
Figure 4 – Connection of the cable of USB-UART converter to the
device “BI-530P TREK”.
Once connected, the device will transmit data about its state to the
terminal. In addition, the user is able to use a terminal program to send
commands to a device and receive response to them. Send preliminary to
device the password to access the terminal in the following format:
TPASS: password;
, where
password
is a password for access to the device terminal (default
value is 11111).
Lifetime of access password after sending is 60 seconds.
After this time, re-send the password to exchange data with the device.
Description of indication
Top panel of the tracking device contains two LEDs that indicate the
current status of the device.
LED “STATUS” (
red
) is on for 0.5 seconds and is off for 0.5 seconds
when GPRS connection is inactive; is constantly on when GPRS
