w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
9
M
aintenance and care
it is recommended to check your vac-
uum’s rotating floor brush and drive
belt regularly for wear or damage.
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
In low cleaning position, turn vacuum over
so bottom side is facing up.
3.
Lift tab 1 and release the three latches
in order 2-4 as marked. Lift off the brush
cover.
4.
Grasp the rotating floor brush at both
ends and lift out.
5.
Clean hair, strings, and other debris from
rotating brush, motor pulley, and drive
belt areas.
6.
Check air passageway for obstructions,
remove any debris from this area.
Replace drive belt
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
With rotating floor brush removed from
vacuum (steps 1-3 in previous section),
grasp old drive belt and remove from
motor pulley and around floor brush.
Discard old drive belt.
3.
Place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
4.
Place ends of rotating brush back down
into slots on sides of vacuum.
5.
Turn floor brush by hand several times in
the direction of motor pulley. If properly
installed, drive belt should center itself on
rotating brush.
6.
Insert front edge of brush cover, rotate into
place and snap 3 latches.
4.
2.
6.
3.
6.
check rotating floor brush and drive belt
3.
Motor
Pulley
Air Passageway
Motor Pulley
DJ68-00375N(EN)-0.0.indd 9
10. 11. 12 �� 4:23
