w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
11
M
aintenance and care
clearing clogs
Reduced suction or poor pickup may
be due to a clog in the vacuum. if you
notice a change in the sound of the
vacuum motor, check for clogs.
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
Empty dirt container and check upper tank
and suction inlet for a clog.
3.
Grasp the curved wand and separate it
from the hose wand base. Check for a
clog in the base, the wand or in the hose.
4.
Remove the Twist ’n Snap hose from
the vacuum by turning it to the right.
Straighten the hose and unclog with a
long, narrow object such as a broom
stick.
5.
If you notice debris clogged in the con-
necting tube, remove it by pulling it out at
the top and lifting the tube out. Clean the
tube of any debris, and clear any possible
clog from the port to the pre-motor filter.
Reattach tube bottom by first installing the
base and then push in the top of the tube.
6.
If the clog persists, follow instructions for
checking and rotating brush and drive
belt on page 9 and inspect the air
passageway for obstructions.
Replace headlight
1.
Turn power OFF. Unplug power cord from
electrical outlet.
2.
Using a flat head screwdriver or coin, pry
tab on the left and right side out and pull
out cover to remove lens.
3.
Remove the bulb by grasping the bulb
and pulling gently. Replace with new bulb
by pushing it gently into the socket until
the bulb snaps into place.
4.
Reposition lens and snap both ends back
into place.
4.
2.
3.
3 & 4.
5.
Connecting
Tube
Connecting
Tube
Twist and
Snap Hose
Curved
Hose Wand
DJ68-00375N(EN)-0.0.indd 11
10. 11. 12 �� 4:23
