w w w. b i s s e l l . c o m
9
M
aintenance and care
1.
Unplug cleaner from electrical outlet.
2.
Remove the dirt container as described
in the previous section. Grasp the filter
cup located at the bottom of the dirt
container and twist counterclockwise to
unlock and remove.
3.
Grasp the circular filters and pull
straight up to remove.
4.
Separate the outer foam and inner
pleated circular filters. Wash each
individually by hand in warm water.
Mild detergent may be used if desired.
Rinse well, then air dry thoroughly
before putting them back together
and replacing in filter cup.
5.
The filter cup may be washed in warm
water with a mild detergent. Make sure
it is completely dry before reassembling
with filters.
6.
The upper tank and primary separator
may be wiped clean with a damp cloth.
Reach underneath the upper tank and
turn the rim of the primary separator to
unlock. Pull straight down to remove.
Cleaning the pre-motor filter
1.
Unplug the cleaner from electrical outlet.
2.
The pre-motor filter protects the motor from
debris. It is located underneath the dirt
container and filter cup in the center of
the round part of the Lock ‘n Seal lever.
3.
Remove the small, round, pre-motor filter
and any debris on top of it. Rinse well
under warm water, then air dry thoroughly
before replacing.
Cleaning the inner & outer circular filters
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
Pre-Motor
Filter
NOTICE:
This product is intended for household use
only and not for commercial or industrial
use. Vacuuming of dust from products like
plaster, concrete or ashes will damage the
motor and void the warranty.
