Bischoff & Bischoff GmbH | 14.02.2020
EN
13
12
Eltego
| Electric Wheelchair
Electric Wheelchair |
Eltego
3.5.2 Backrest
The angle of the backrest of your electric wheelchair has a manual
recline function and can be easily adjusted to the wanted position by
pulling the strap at the lower end of the backrest. You also have the
option of folding the backrest completely down to the front.
•
You can adjust the angle of the backrest from 90° to 120° in four
steps.
•
Pull the cable behind the back while holding the backrest with the
other hand.
•
After letting go of the cable the bolts will lock into place.
3.5.3 Backrest Sag
A well-adjusted backrest makes it easier to relax and sit for a long
time and effectively reduces the risk of developing pressure sores.
Make sure there is enough sag in the pelvic area.
•
Remove the padding from the tension straps of the backrest.
•
Loosen the Velcro fasteners on the straps.
•
The straps are adjusted one after the other from the bottom up.
•
Slide the padding over the tension straps again.
3.5.4. Suspension
You can adjust the suspension to your weight for a comfortable drive.
•
You will need a special wrench to adjust the spring deflection.
(Please contact the service department)
•
Pushing the spring together results in a reduced spring deflection
and a “harder” setting.
•
Expanding the spring increases the spring deflection and
guarantees a “softer” setting.
Make sure that both suspensions on the right and
left are adjusted the same.
3.5.5. Armrests
The armrests can be completely taken off to be able to get in and out
of the chair from the side. In addition, the height of the armrests can
be adjusted. They can also be adjusted sideways by adjusting the side
parts (see side parts).
Removing the armrests
•
To remove the armrest, loosen the wing bolt and pull out the
armrest to the top.
•
When installing the armrest, make sure it is inserted all the way
and fastened again.
Adjusting the height
•
First take the armrest out of the mounting.
•
Remove the arresting bolt and screw it back into the armrest at the
desired position.
•
The lowest hole represents the maximum height of the armrest.
04
05
06
07
Make sure that both bolts on the left and right are
completely locked in place.
