Bischoff & Bischoff GmbH | 14.02.2020
EN
23
22
Eltego
| Electric Wheelchair
Electric Wheelchair |
Eltego
4.5. Leg Supports
To make it as easy as possible to get in and out of your wheelchair,
you can fold the footrests up or pull the leg supports to the side and/
or take them out.
•
Open the locking mechanism to pull the leg support to the side.
(Fig. 20)
•
In the “outside position“ the leg support can be taken off
completely. (Fig. 21)
•
To reinstall the leg support, repeat the steps in reverse order.
•
Push the leg support back to the front until it catches with an
audible click.
4.6. Anti-tipping Wheels
The anti-tilt rollers prevent the wheelchair from tipping over
backwards.
•
The anti-tipping wheels are especially recommended for novice or
leg-amputated wheelchair users.
•
The anti-tipping wheels are attached to the left and right side of
the frame as a pair.
4.7. Lighting system
The electric wheelchair is equipped with a lighting system in
accordance with the German traffic regulations (StVZO) for safe
participation in street traffic (fig. 23). The lighting unit consists of
2 front reflectors, 2 side reflectors and 2 rear lights, which can also
serve as reflectors simultaneously.
The active components are controlled with a button next to the
joystick (fig. 24). Press the button briefly to switch the lighting system
on/off. Hold the button down to adjust the brightness. The lighting
system is independent of the controller and can also be operated
when the wheelchair is switched off. When exiting the wheelchair,
make sure that the light is switched off.
4.8. Rear reflectors
The electric wheelchair is equipped with two rear reflectors which at
the same time also serve as reflectors.
Switch the rear on as soon as it starts to get dark, or when there
are poor light conditions, so as to get a better perception of your
surroundings.
They are attached by a clip to the frame at the back and can simply
be pulled away to the side. By pressing the red button, you can switch
on the rear reflex reflector, choose between different flashing modes
and also switch it off again.
20
21
22
24
25
23
